Or perhaps try to direct connect the kd20 to the tftpserver (without any switch, router or so in between), I have read that these errors comes often from half/full duplex or routing problems.
I tried to load files from sata but tftp, was more suitible for me.
You need to active IDE via ide reset if its not done allready, then you can load from ext2 via ext2load.
I don't remember the actual syntax, but I think google might help.
I tried to load files from sata but tftp, was more suitible for me.
You need to active IDE via ide reset if its not done allready, then you can load from ext2 via ext2load.
I don't remember the actual syntax, but I think google might help.